Skip to content
DavisvilleLock & Key Co.Open 24/7 (289) 217-4629
Detached satin-nickel lever hardware, tubular latch and strike plate on a wooden workbench. — Lock Replacement & Upgrade, Toronto

Change or rekey · Toronto

Lock Replacement & Upgrade

The brass handleset has gone blotchy and green where the winter salt reaches it, and the coating on the deadbolt is lifting in flakes. It still locks, but it looks tired beside the fresh paint on the door.

In plain words

After a break-in or an attempt, the door tells a story, and the new hardware should answer it. Splintered wood around the strike means the jamb gave before the lock did, so the repair pairs a heavier deadbolt with a reinforced strike and 75 millimetre screws that reach the framing behind the jamb. A bent bolt or cracked housing is replaced with a graded deadbolt whose bolt has a hardened core. A knob lock that was bumped or forced is swapped for a set with better pins. The aim is a whole opening that resists force, not merely a shinier lock.

Sound familiar?Toronto

The call
The house is fifteen years old and every exterior door still wears the light hardware the builder fitted: a short bolt, a thin strike held by two small screws, and a knob lock that never suited a street entrance.

NextHow the visit goes

Lock Replacement & Upgrade · Toronto

How the visit goes

Person in a green cap holding a brushed-metal deadbolt against a dark door while a yellow drill rests below it. — Toronto
  1. Scene 1

    The key plan for the whole house

    A lock is only half of a system; the other half is who holds which key. The locksmith asks how many exterior doors there are, which ones should open with the same key, whether a garage man-door or a shed should join them, and who in the household needs a key of their own. If keys have been lent out over the years, the plan can retire all of them at once. Where copying keys without permission is a worry, a restricted keyway can be offered. Settling this before the hardware is chosen means the new locks arrive ready to be pinned alike rather than fixed up afterwards.

  2. Scene 2

    Fitting the latch or bolt to the door

    Most modern latches and bolts adjust between the two common backsets, so the unit is set to the measured figure and slid into the edge bore. A spring latch goes in with its bevel facing the strike, while a deadbolt is oriented the way its markings or instructions call for, not by that bevel rule. The faceplate should sit flush in its mortise; where the old cut-out differs in shape or size, the mortise is trimmed with a sharp chisel, or a round drive-in collar is used where the door was prepared that way. The bolt is checked to travel freely before anything else goes on, since a bolt that binds in the door will bind under the key too.

  3. Scene 3

    Every lock tried the way you will use it

    Before the tools go back in the van, each lock is operated from both sides with the door open, then closed, then closed hard against the weatherstrip. The latch should catch on its own when the door swings shut, the deadbolt should throw to its stop with a fingertip on the thumb-turn and no shoulder on the door, and the key should turn without lifting or jiggling. You are invited to try each one yourself and to lock up behind the locksmith. Anything that felt marginal has been adjusted, so the door you close that night behaves the same as the one you tested.

In the van

  • Knob or lever entry set
  • Key blanks and key cutter
  • Handleset with matching deadbolt
  • Adjustable latch or bolt
  • Chisels, mallet and hand screwdrivers

What shapes the quoteDavisville Lock & Key Co.

Changes to the door preparation
Adjusting a strike mortise is minor; boring a new hole for a deadbolt, fitting a filler plate over an old mortise pocket or adapting a thick door with extension kits is quoted as its own item.
Grade of hardware
A light Grade 3 knob set, a residential deadbolt with a strong label rating and a Grade 1 commercial-style deadbolt are different products at different levels, and the quote follows the grade you choose for each door.
Keying alike and rekeying
Pinning new cylinders to one key and repinning existing locks to match is work per cylinder, so a whole house on a single key is quoted by the number of locks joining it.

FeesSame any hour

Have it ready

Before you call · 0 / 3

(289) 217-4629

Ask us anything about locks

Do I have to prove I own the home before you change a lock?

The locksmith will ask, and it is a sign of a careful trade. Photo identification with the address, a deed or property tax notice, or a mortgage or insurance document is plenty for an owner. Tenants show a lease and the landlord's consent; landlords show ownership and confirm the tenant will receive keys. It is a short step that protects everyone with a right to that door.

My door has glass beside it. Should I fit a deadbolt keyed on both sides?

A keyed interior cylinder means finding a key to get out, which is not what you want on a door people use every day. The steadier answer for a door with glass is a single-cylinder deadbolt with a thumb-turn, combined with a reinforced strike, a longer bolt and a security film or laminated glass in the sidelight.

Can you replace the lock on a sliding patio door or French doors?

Yes. Sliding doors take a replacement mortise hook lock sized to the rail, often with a keyed exterior, and benefit from a secondary foot bolt or a pin through the frames. French doors are secured by treating the inactive leaf properly with flush bolts into the head and sill, then fitting a deadbolt to the active leaf with a strike into that reinforced edge. Both are routine parts of a residential upgrade.

Torontoinformation

TorontoOntario

Lock Replacement & Upgrade · Bedford Park, Davisville, Lawrence Park, North Toronto

Town
Toronto
In business
27 years
Hours
Open 24/7
Nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

2021 census: what it means at the door

Every square is one home in a hundred.

  • 58 in 100 homes · older homes
  • About 58% of homes in Toronto were built in 1980 or earlier, according to the 2021 Census.Older doors are usually thicker and made of solid wood, which is good news. They take a deadbolt well, hold longer strike screws, and reward reinforcement. The locksmith measures the thickness and backset so new hardware fits without fresh holes.
  • Single-detached houses make up about 23% of homes in Toronto (2021 Census).Suite doors in buildings often have a viewer, a chain and a deadbolt fitted at different times. A locksmith can tidy that into one sound arrangement, with a properly set deadbolt and a strike that holds, without altering the door's face.

Source: Statistics Canada, Census Profile

Open Toronto in Google Maps

On-site assessment

Request a visit.

The brass handleset has gone blotchy and green where the winter salt reaches it, and the coating on the deadbolt is lifting in flakes.

(289) 217-4629, open 24/7.